Chicco PASSEGGINO S3 Bedienungsanleitung PDF herunterladen (Seite 13)

3. Raise the stroller as shown in diagram 3; the stroller

will start to open.

WARNING: Before use, ensure that the stroller is locked

in the open position, checking that the locking devices

located at the sides are locked.

HOW TO OPEN/CLOSE THE FRONT FOOTREST

The stroller is supplied with the front footrest closed, to

make the stroller more compact.

WARNING: Lock the footrest in the use position imme

diately after opening the stroller (please refer to the para-

graph: “How to open the stroller”).

4. Turn the footrest as shown in diagram 4.

5. Open the locking device located at the rear of the foot-

rest, then align the hole located on the footrest to the

locking joint, and slide the joint until it is safely locked, as

shown in diagram 5.

WARNING: Check that the footrest is locked in the use

position.

To make the stroller more compact when closed, after

removing the front wheel, fold the footrest, carrying out

the above operations in the reverse order.

HOW TO FIT/REMOVE THE FRONT WHEEL

6. The front wheel is different from the other wheels be-

cause it has a rapid removal system similar to the system

used by cyclists (diagram 6).

7. Insert the joint of the wheels into the correct slots lo

cated at the end of the front fork, as shown in diagram 7;

Check that the axis of the wheel is correctly inserted to

the end of both sides of the fork.

8. After ﬁtting the wheel, tighten the locking lever, ﬁrst

turning it, and then folding it as shown in diagram 8.

To remove the front wheel, loosen the locking lever and

detach the wheel from the fork, carrying out the above

operations in the reverse order.

WARNING: Check that the wheel unit is safely locked

into position.

WARNING: Always check that the lever is locked cor

rectly.

HOW TO FIT/REMOVE THE REAR WHEELS

The rear wheels have internal braking crowns, as shown

in diagram 9.

10. Insert the joint of the wheel into the correct slot, until

a “clak” is heard, signalling that it is locked into position;

repeat the operation with the other rear wheel.

11. To remove the wheels, raise the release buttons

shown in diagram 11, and remove the ﬁrst wheel. Re

peat the operation with the other rear wheel.

WARNING: Check that the wheel units are ﬁtted cor-

rectly.

The wheels may be removed to make the stroller more

compact when closed.

HOW TO FIT/REMOVE THE COVER

12. Insert the small round plastic devices, located at the

sides of the cover, into the slots inside the tubes (dia-

gram 12); ensure that they are completely ﬁtted to the

end of the slots (diagram 12 A).

13 Warning: The crotch strap is ﬁxed to the seat support

of the frame (as shown in diag. 13 A): To use the crotch

strap correctly, slide it through the hole of the cover, as

shown in diagram 13 B. To use the safety harness cor

rectly, please refer to the paragraph “How to Use the

safety harness”.

14. Fasten the 2 press studs (diagram 14).

15. Fit the two cover ﬂaps of the armrests, inserting the

plastic joints of the cover into the holes located on the

armrests (diagram 15).

16. Before ﬁxing the seat to the frame, check that the

backrest’s adjustment belt (Diag. 16-component A) is

inserted correctly into the holes B. If it is not inserted as

shown in diag. 16, insert belt A inside the two holes B.

Then ﬁx the 5 male, plastic spring catches, located on

the fabric cover, to the 5 female, plastic spring catches

located on the frame, as shown in diagram 16.

WARNING: Check that the cover is ﬁtted correctly to the

frame of the stroller.

HOW TO USE THE SAFETY HARNESS

This stroller has a 5-point safety harness featuring two

shoulder straps, a lap belt and a crotch strap with dual

safety buckle.

The safety harness has dual safety buttons to prevent

the accidental opening of the buckle by the child.

17. After seating your child in the stroller, insert the two

clips into the buckle and adjust the shoulder straps as

required, passing them through the holes at the most

suitable height. Adjust the height of the shoulder straps

and lap belt using the buckles.

18. To unfasten the lap belt, press the red central but-

tons with one hand and, at the same time, press the two

lateral pins.

WARNING: To guarantee the safety of your child, always

use the safety harness.

HOW TO ADJUST THE BACKREST

The backrest can be adjusted through a belt adjustment

system.

19. To lower the backrest, it is necessary to operate the

rear adjustment system. Press the two side buttons as

shown in diag. 19, adjusting the backrest until the de

sired position has been reached.

Vice versa, to raise the backrest, it is necessary to press

the two side buttons of the adjustment system, and pull

the strap until the desired position has been reached.

WARNING: The child’s weight can make these opera

tions difﬁcult.

REMOVABLE BUMPER BAR

20. To remove the bumper bar, press the two small but-

tons located in the inner side of the armrests (diag. 20),

and pull the bumper bar towards your direction.

HEIGHT ADJUSTABLE HANDLE

To make the stroller more ergonomic and compact, it is

possible to adjust the height of the handle.

21. To raise or lower the handle of the stroller, operate

the external buttons, and adjust the handle to the posi

tion that you ﬁnd most comfortable (diag. 21).

SAFETY BRAKE

The safety brake locks both the rear wheels of the stroller

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19

Kommentare zu diesen Handbüchern

Keine Kommentare

Chicco PASSEGGINO S3 Bedienungsanleitung Seite 13

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kinderwagen Chicco PASSEGGINO S3